Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Removing of distributor drive gear from rear of cam.

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
daniel  



Joined: 18 Jun 2009
Posts: 687
Location: Sydney, Australia
PostPosted: Fri Mar 04, 2022 1:43 pm    Post subject: Removing of distributor drive gear from rear of cam. Reply with quote
I have tried everything I can think of. A combination of a tensioned up puller plus heat from the oxy got it to move about 0.5mm but no more. Have already put a minor chip in the gear so don't want to force the issue to much.

Any magic tricks out there?
_________________
Over the top of skyline, total brake failure.... hit the wall at over 200 kp/h at the dipper, so anyone who has to brake for the esses is a pussy.
1977.5 Race Car, CAMS Group S Spec
1989 944 Cabriolet
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group