Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Metering head rebuild advice

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Last Triumph  



Joined: 17 Oct 2016
Posts: 123
Location: UK
PostPosted: Sun Feb 05, 2017 12:36 am    Post subject: Metering head rebuild advice Reply with quote
1980 2.0 NA - cast head, stainless diaphragm.

I'm about to rebuild my metering head and made the mistake of not keeping tabs on what springs and washer went in which port.

Is this critical?

3 of the 4 washers are the same thickness where one of them was 0.1mm thinner than the rest.

Does this matter?

Any tips on this element of the rebuild?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group