924Board.org

jjames · Joined: 10 Aug 2006 Posts: 48

ok people, thanks to you I almost have the 924 on the streets! hopefully, the last obstical is this timing belt pully problem. I removed it today to discover that the roll pin that holds it to the crank is sheared off. I can drill it out of the pully but, getting it out of the crank is going to be harder. Any suggestions?

Lizard · Posted: Wed Sep 13, 2006 10:20 am Post subject:

it is a much softer material than the crank so drilling it out shouldnt be too daunting of a tast,

maybe get your 928 neighbour to give you a hand
_________________
3 928s,

jjames · Joined: 10 Aug 2006 Posts: 48

i AM HAVEING A VERY HARD TIME FINDING THE PIN THAT HOLDS THE TIMIMNG BELT PULLY TO THE CRANKSHAFT. dOES ANYBODY KNOW WHERE i CAN GET ONE? Sorry for the caps but, I am to lazy to retype it.

Lizard · Posted: Mon Sep 18, 2006 11:26 am Post subject:

From PET Version 5.0

924 78 MG 1 SG 02 Illustration 102-00

Item 2

Part # 023 255 1

called Tension Sleeve, 4 x 12
_________________
3 928s,

jjames · Joined: 10 Aug 2006 Posts: 48

thanks again, you have been a very big help to this newbee