Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Torque tube differences

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech.
View previous topic :: View next topic  
Author Message
Cbass  
Guest
PostPosted: Mon Jul 29, 2002 11:47 am    Post subject: Reply with quote
I have been told the torque tube for the snailshell is shorter than the Audi transimissions tube. How much shorter is it, and are the splines the same? If an Audi tube was shortened and had new splines machined, would it fit?
Back to top
Cbass  
Guest
PostPosted: Fri Aug 02, 2002 7:10 am    Post subject: Reply with quote
The reason I ask is, I am picking up a G31 with a bad torque tube. There is damage around the very tip.

I know the G31 had a shorter tube, as opposed to the Audi 931 and 944 tubes. My crazy idea is that if I can get an Audi inner shaft, I can have new splines cut into it, and use it with the G31's tube. I need the extra length to attach the tube to a Ford bellhousing...
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech. All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group