Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

DITC question

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech.
View previous topic :: View next topic  
Author Message
bho  



Joined: 03 Nov 2002
Posts: 17
Location: Richmond, B.C.
PostPosted: Tue Jul 18, 2006 2:50 pm    Post subject: DITC question Reply with quote
One of my flywheel sensor wires leading to the ditc unit has broken at the crimp point of the three prong connector. Trying to solder the wire back at this location will likely not last too long. Has anyone been able to source a new connector from somewhere?

Has anyone come up with an alternate solution for this connector?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech. All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group