924Board.org

thanks much for the replys... not it off to get some fluid.

THANKS AGAIN

hi, I've got an `80 931 5spd and I need to bleed the brakes and clutch...

what would be the correct sequence for the bleed process???

TIA

r0adawg

oops, for got the important stuff...

1980. sticker on driver door frame says dec 1979..

and the fuel pump is correct, blew that one a while back...

thanks

I can't seem to find out where this block is referenced...

thanks for the help

Stamp

Warning, image is 1.5 meg..

http://www.jeffnet.org/~jesseb/Porsche/DSC01779s.JPG

purchased an 80 dist with vaccum advance. car wiring is 80, no DITC behind radio, just alarm box. the only thing in the car thats `81 is the engine, all wiring to engine is 80.

for right now, it wi ...

Smoothie: the body is 80 924 Turbo. the engine is '81 924 turbo. have aftermarket starter, alt, coil, cap, roter, wires. I think that its all good. it did have the a/c option cept when the p/o of ...

thanks for the help. I will have to wait for a new fuel relay for right now. as it is working now I have a switch inplace that I have to turn on for the pump with a standard 8A fuse. so far starts ...

I recently had a fuel relay go out on me, as I was going through the troubleshooting steps, I found that the pump does work, even better than with the old relay before it was going out. my pump now ...

well, got to drive my car, only to be supprised with something failing on me in the middle of traffic..

getting good spark and quick trun over, so next was gas. full tank and nothing getting to the ...

just notice a leak on my clutch pedel while installing the hot start fix.

the leak is noticed under the dash just as the clutch goes through the firewall..

I'm hoping that I have to just tight ...

thanks, at least I'm using the right window...hehehe

I'm off to get brake fluid, and a long bleed hose, not too mention the good gas

well, I replaced the starter with the correct type. Fired it up.. and supprise... it acutally started... just about 50 deg advance... oops.

retimed it and it runs a little high on the rpm about 2 ...

well, I think that I need to get a new starter... from the front its cranking ccw....

what if any dammage to this poor little car have I done??? ....

Got my engine to finally turn over. have a couple of hopefully quick ones here...

1 ) what direction does the engine normaly rotate ie cw or ccw??

2 ) have recently gotten smoke or steam comi ...

yes. when can we meet up... would like to get it finished

thanks again
stamp