924Board.org

Can someone please refer me to a mechanic in south/central Georgia. I have been working on my 924S for months and getting nowhere. I am ready to get it fixed before I set it on fire. Thanks

Many thanks for the photos. Now I will have to figure out how to get to them this weekend.

Thanks for the quick replies. I will look for the cluster of grounds but don't recall seeing them. It may well be the case that I don't know what I am looking for. I will also have the coil tested.
T ...

I am ready to drive this car off a cliff. As suggested, I replaced the engine grounds (which I assume are the 2 negative battery cables), cleaned what I think is the fuel pump ground (really could not ...

I will do the tests. Thanks

Thanks guys, now I have an idea of where to start. I will replace and test when my budget allows it. Again, Thanks

Please help with my misfiring problem. It will miss at any speed but particularly when I let off the clutch after upshifting. I have also noticed that at idle the rpms will sometimes drop considerably ...

Thanks for the reply. I have read every thread concerning rough idle and
motor mounts seem to be the logical answer. However, there was no problem before I began the repairs and the engine seems to ...

I jumped on a project that was beyond my skills. Replaced waterpump, head gasket, new plugs and wires, distributor cap, rotor.etc..It took me months since I had to redo it several times. Finally got i ...

Thanks for the reply.It makes me feel better.I hope you are right Again thanks.

I just finished putting on a head gasket, timing belt, and all new gaskets.This was my first big project.When I got it back together and cranked it up, after it got warm I got alot of smoke from under ...

My weekend project (replacing waterpump,belts,and head gasket) has become an expensive month long project so far. First I stripped the smaller allen head bolt on the front of the head.Next I broke it ...

Thanks so much for the help. Looks like I will be ordering more nuts and bolts. Again, I appreciate the information.

I am in the process of replacing the head gasket on my 87 924S. I realize that I will be replacing a lot of gaskets before the job is through (intake,exhaust,etc.). My question is, Do I use any type o ...

I sincerely appreciate all the replies.The shop replaced the seal in the high pressure port.I know absolutely nothing about ac and therefore do not know if the retrofitting was correctly done.However, ...