924Board.org

I have the later design, with a rotary blower speed switch, 2 half-width sliders and one full-width slider.

Speeds 1 has not been working since I had the car 3 years ago, but now speed 2 is not wor ...

Could anyone tell me where the resistors for the fresh air fan speed controle are on a right hand drive 1982 924. Before I dive in stripping things down.

thanks

John

The oil preasure does go above 2bar when the engine is cold so I suspect the gauge is working correctly.

Will try and get new spring piston and seal for the pump and see if it improves the preasure ...

Not sure what the bearing clearances where, I had the crank checked and was told all it needed was a polish and it would be okay using new std bearings again. I bought the car knowing it needed a rebu ...

Last year I completley rebuilt and overhauled my 931's engine including new JE pistons,turbo, bearings,rebuilt head.

But of late when the engine is warm (just over halfway on the temp gauge) the oi ...

Fixed it....

What a pig though getting the speedo cable off, it had what looked like factory red paint across the nut and threads. I guess to indicate that it had not been tampered with.

The sma ...

cheers,

Is there a knack to getting the clock out of the dash.

I need to get it fixed because my insuraces is limited milage. If the milage hasn't gone up they will think I'm fiddling them and v ...

My mileometer has stopped working but the speedo still works fine,are they both driven by the same cable and there is an internal problem with the speedo. Or does the cable just do the miles and the s ...

The turbo was a NEW unit which I fitted about 200 miles before I had to rebuild the engine due to a piston ring land breaking on no.3.The engine rebuild took about 6 Weeks. The blue smoke seems to hav ...

Cheers guys for you reassurance, I was just a little concerened by the blue smoke as I say it did it for about 5 miles or so,especially when I built the revs up, but seems alittle better now.( haven't ...

I have just finished rebuilding my 1982 931 engine, it has had the crank reground, new bearings, rebored block and new 87mm JE pistons,and the head has been rebuilt.

Got it running today but the o ...

Made a slide hammer and removed the clutch fork pivot okay. Engine flew out. But it looks a bit tricky replacing the engine and clutch fork while lining the pivot up pin again. Is it as tricky as it ...

I see the error of my ways now, my munual doesnt cover the hydrolyic clutch. I have seen the pivot I have to remove and am going to make a tool to extract it at work today.Thanks for your help guys... ...

No didn't know I had to, said nothing about it in the manual. Do I need to remove it......any tip on removing it.

Thrying to removed my engine but it will only pull 1/2 inch from the torque tube housing then stops. Have a forgot something or might it just be the spline shaft stuck in the clutch plate.

Regards ...