924Board.org

My coworker has a 924S that is mechanically sound. It had been working well. He had been driving it a few times a week for the past few months. He filled up with Ethanol gas the last time and drove ...

My coworker has a 924S. I have a 951 turbo that I was intending to use for my 931, but I doubt I will ever get around to it. So, I plan to sell it to my coworker. I am thinking it will need a rebui ...

I have a co-worker with a 924S. He has a fuel leak from either the fuel line (part number 944-356-943-03 or 944-356-945-03) and needs it replaced. Is there a way to replace the lines with new ones f ...

Is that just the extra turbo binder or is the whole set turbo specific?

I plan to remove the engine in my 931. I have section 10 (10-2 through 10-7) of the FSM. Are there any other instructions that I should look for and use to remove the engine?

I'm estimating $1k. I'm hoping for the best though. It'll be a long process though.

Roughly how much is it to repair a head following a timing belt break? And what is the breakdown of the expenses (not mechanic labor)?

The part I'm talking about is part #4 in the Transmission factory service manual page 34-55. It's description (on the next page) is "Support for boot." Maybe I had it too low and it seemed ...

What is the purPose of the shifter rubber boot support brace? If I were to remove it, would there be any adverse effects with shifting? This is on the "snail shell" tranny.

My brother was driving my car Tuesday night when he heard a thunk on the passenger side and it wouldn't drive anymore. After he got it towed back to my house, I took some pictures:

http://lh5.ggph ...

I would rate it as more severe, especially under heavy acceleration. How easy it is to check the wastegate diaphragm?

I read [url=http://www.924board.org/viewtopic.php?t=22888]this thread about checking the charge tube, but it didn't move separate from the turbo when I shook it.

While driving the car, under regular to hard acceleration, the car starts bucking. It happens all the time, meaning acceleration while going slow (20 mph) or fast (60-70 mph). Any suggestions?

We were able to remove the cotter pin and castle nut and get it to pop with a pickle fork. Now we just can't get the ball joint to press out. The "receiver" parts, in the bottom left of pi ...

Has anyone removed a 1997 Honda Civic lower pressed ball joint? We have a few bolts taken apart so we can get to the ball joint. We tried using a ball joint remover, but that's not working. I belie ...