924Board.org

Normally to fine tune system pressure you can add or remove the shims that you see when you pull out the pressure regulator. Though in your case your quite long way from the fine tuning range. I could ...

Looks like a neat kit Morghen, if I cant get it running will hit you up.

If i were in your case I would change all the seals first anyway to be sure Im not chasing or modding anything that i should ...

Removed and inspected the system pressure regulator. Looks pretty good, o rings seem fine and no wear on the control piston. Had two shims installed.
Guess the spring could have weakened over time wh ...

cheers for the quick reply cecdric.
cool will get it rebuilt and see if that fixes it.
no boosting atm for me just really rough and crashing idle atm lol

Hey Guys,

After a complete engine rebuild on my 81 S2 924 turbo and running the car it was idling rough and cutting out under acceleration.
Seemed lean so proceeded with fuel system pressure test ...

Hey guys haven't been on for a while to update my cars problems but feel like its time to get stuck into it again.

Last time I posted my car was running fine for the first 5 mins or so after startu ...

Hey guys,

Basically I need to find a working impulse sender (flywheel sensor) for my car or I'll be doomed to take the bus forever

The part 931.606.021.00 is NLA and could only find them on ...

Sorry for not replying but I have been away over the holidays a nice break from the 24.

Couldnt get my hands on a cis tester today as the shops near mine were closed but will get one next week. Gue ...

Thanks for the info guys,

It was the thermo time switch that i fixed up then.
Will look into the wur when i get the chance.
Any way to bypass the wur to see if it is causing my problem?

Ok cars still not running,

had a brief chat with someone who used to work on these cars and he said that what i was describing sounded like a dodgy temperature sender.
Said that after the engines ...

There is no vacuum line connected to that specific port. It is just some sort of venting hole.

Thanks, was stuck here for quite a bit.

Still lost, but noticed that the battery light came on at t ...

crank sensor and all the wires check out. Decided to check out the wur and found out that im missing a vacuum hose i think, just under the electrical connector to the wur. But cant seem to figure out ...

Thanks for the reply smoothie,
Did everything you recommended but once the car got warm again it start to sputter untill it died (tach flop).

There also was no water dripping or around the ditc bo ...

Ok managed to unplug and reseat the connection to the DITC.
But still the car backfires on warmup and eventually the tach flop of death.

Never had this problem before i had the engine out to fix t ...

Yup same thing, backfires for a bit and then all of a sudden u rev it and the tach flops to zero and cuts out.
Unfortunately i couldnt unplug it, casing was crumbling as it was all coroded.
Had to p ...