924Board.org

I was searching around and came across this listing on Ebay. Interesting.

https://www.ebay.com/itm/166860874752

https://i.imgur.com/oUjR9U8.jpg

https://i.imgur.com/8HJAeoD.jpg

that is int ...

Hi Folks... I'll be removing the transaxle on my '79 NA this week to get at the fuel tank and so am starting to think about the likelihood of needing to replace the mounts.

I've heard rumours that ...

I looked around a little bit for one for my car a while back, but didn't see anything out there. Obviously mine's a year newer and a 931, but it does have a 23mm bore. I didn't dig much because mine h ...

i have a 1979na, im trying to rebuild the ATE master cylinder but struggling to find a source for the kit, mine is a 23mm bore which is strange as from what i understand that year would have been 19mm ...

has anyone else got any thoughts on this...i must admit with the 924 tendency to rot out here i thought there would be no shortage of suggestions!

Thanks for the reminder!

I’m seriously considering relocating the battery however, probably to the spare wheel well, I’ve always thought the design of the battery tray functionality as a rain g ...

Hey folks, ive just finished the welding on my very rusty battery tray.

(Anyone who has done this with beautiful neat welds i salute you, this has to be the hardest most awkward weld job ive done! ...

If they are standard size pistons,86.5mm you can get new rings faily easily( if you need some i have some in stock here in UK) If the pistons are oversize,87mm/87.5mm then your going to have fun findi ...

Depends on your expectation and longevity of the engine post rebuild. Speaking to an engine builder who’s done fast and dirty repairs/rebuilds at race meetings and seen these engine run on for many ...

Hi folks, i need some general advice about piston rings and honing on my first 'engine job'...

Having removed the pistons and rings in order to check and clean clean clean..
my question is should ...

Check out this thread, I had the similar issues a month or so ago and managed to get through it. The bleed nipple can be extracted with a bit of patience and a few tricks.
If you have the calliper o ...

Thanks, thats a pity, it was all going so well!

could you give me any guidance to what could be done to rectify it?, im new to head work so learning every day..

many thanks!

Hi all, im scavenging for more experienced opinions on things im finding on my engine refresh..!

pulled the head today and found some damage on the valve seats pictured, how worried/concerned/tota ...

From my spare pump

https://ibb.co/RH5XN4C

thanks for this, that helpful...i think mine isnt too bad and im leaning towards just assuming its a manufacturing issue, ive cleaned it up today with t ...

thanks guys, i think the impression im gettign from here and also the facebook group is that its prob not actually an issue and as long as the passageway is there to allow oil to move freely then it c ...