924Board.org

One way to check for clear coat is to see what is on the buffing pad. If the pad matches the car, then it does not have clear coat.

Depending on your skill level. You can actually wet send the ca ...

I had great success with replacing the WUR on my 77 924. The car starts up after running - engine warm, the idle has smooth out, lots more power.

Thanks for your help!

Check out the following Website:

www.rockauto.com

WUR - Beck Arnley == $70.79 with 17.00 core charge. Rebuilt

I also purchased fuel injectors. Beck Arnley $38.79 Each.

Rock Auto has al ...

Thanks for you help again. I should get the WUR tomorrow.

Do you remove the WUR first than the lines? Or lines and then WUR?

Thanks for your help.

What is the best way to remove and replace the WUR? I have checked Haynes, Clymer and Chilton on the proper way of removal. No detailed info.

Any ideas? Estimated time to R & R?

I have found the Vacuum hose diagram for a 77 924 Porsche. This diagram matches the setup in my car.

Haynes Porsche 924 and Turbo Manual. Page 105 in the manual.

How much was the hose kit? ...

Any comments on this year and model? I am looking at purchasing a second Porsche. Any common problems? How is the performance and the engine in general 2,479cc? I believe this engine was carried o ...

It does look nice! Where did you buy it in Rochester? I was in Rochester on Friday. How much did you pay?

Check at Automotion.com

It is based on year of car. 76-86 924/944/966 same seal

I have a Ford Crown Vic Police Interceptor that I use for work. I have a lot of current draw with the use of the lightbar, strobes and sirens. I have found that when a battery is discharge, that the ...

Can you use a dwell meter to set the air / fuel mixture with a dwell meter?

All I used was a 3MM Hex head key. It was about 5" to 6" long. It had a 90 degree bend to it. It was nothing special. It worked well.

I ended up tweeking the mixture. It was a little too bit lean. The idle is smooth now. It drives very well. My next step is to take it in and have it adjusted by a professional.

The CIS is quit ...

the air fuel mix requires a 3mm LONG handle allen key yes,
I would first replace the ign wires, cap rotor, and spark plugs if you havent, after that possibly have the air fuel mix checked, however I ...