924Board.org

I had to order mine, no one in El Paso carries it. Still have it on the side for the engine rebuild.

Good to hear your doing fine Dan, have a safe trip, same thing for Grenadiers, enjoy the trip

great trip dan , I wish I could take nine out as well one future plan is to go south of mexico trough the golf of mexico coast side... but wont happend at least for a while. keep on going

you can also use this one from harbor tools and just replace the center shaft with one of the head bolst, thats how I took out mine

http://www.harborfreight.com/catalogsearch/result?q=pilot+bearing

Its a new clutch so by the time the 931 lump is dialed in with the intercooler! It will be time to swap outthe torque tube and rear carrier. Something like that.

what I mean is that if your gonna t ...

well so far I plan to finish my engine and bolt it on the torque and tranny altogether, and lift the car like say 3 feet in the air and slide it under the car and then just desend the car enough and t ...

did these mounts got made?

horrible car its like when surgery went bad.

You could do it yourself.

to busy to do it myself, but i do like the idea.

I found a place in town that does it

http://www.elpasopowdercoating.com/

Got to go check the prices soon

Tha looks superb - had no idea it could be done - need to source that for my byclecle as well

I wonder how the dash would look like , really really nice ,

its always great to see what you com ...

envy, I wish mine would buzz

got one two and its fun to drive, kinda of a game to see how high can u get the mpg's per miles deiven

going back to the saabs, I read that the 1978-1980 saab 99 turbo has a 2.0 engine with something like 8.5:1 compression ratio using cis system. I was very tempted to doing a bolt on turbo setup but th ...

wow,, talk about dieseling the engine. keep it up im rigth behind you on the rebuild engine start phase, I plan to run the engine on and engine test stand I'm building to sort out any anomalies, dont ...

Thanks Dave, I appreciate a lot the help, so far not sure what else is needed I will know soon as I start putting the engine back together, so far I have the a NOS cam and the lifters from a previous ...