924Board.org

I got my distributor plug yesterday. Looks like a fine piece of work too!! I won't be posting on the board anymore, but I couldn't drop out until I said, this is supposed to be how you do business!! ...

Okay, I've read about a thousand posts on brake upgrades and I'm still confused. I've got an 81' 931 with m471 suspension that I'd like to fit 951 calipers and rotors on all 4 corners. The speedo is ...

Makes me wish I need the trigger wheel too!!!

Unless anybody wants to build a toothed drive for a supercharger with a trigger wheel attached!

Darren

Yup....It's a wind scorpion A.K.A. "camel Spider". Going to the desert in the military there are a million rumors about how they climb on you in your sleep and numb you then eat a large pat ...

Are there any block off plates not spoken for? If there is any left give me payment info and I'll send some money!
Darren

Are there any block off plates no spoken for? If there is any left give me payment info and I'll send some money!
Darren

I'll let the signature line speak on the 3 porsches question.....

Eastwood has a cheap zinc plating kit that looks good. I'm with you though, I hate rusty bolts!
Darren

Once again,
The how to is posted on this site. I followed the instructions as close as I could even buying the exact speck of aluminium. I'm not going that route anymore, but that won't stop s ...

I've recently discovered Paragon products has the correct female Heim joints and that is obviously the way to go. I guess the question is if the aluminium is dangerous why is this site publishing thi ...

okay,
finished rebuilding the rack. Measuring roughly from steering knuckle to steering knuckle is about 51.5 inches. if I but the heim joint to the threads of the inner tie rod it works out t ...

I've been looking at those pictures. I downloaded them a while ago. If you read the article in the tech section, the sleeve is actually for the heim joint to screw into then the sleeve screws over t ...

I was thinking that 6 in. would be for both after measuring, but I didn't know for sure. I'm suprised nobody has done this mod. Well I guess I'll just do my best measuring and go from there!
Darren

No,
I haven't tried to measure the bumpsteer, but it is a well known problem with these cars lowered. My plan was to build the kit and work out the bugs when the car is put back together. My ...

cooler air is denser air.

Doubtful that there would be much in the way of seat of the pants, but it is an improvement. I don't think making the duct out of aluminium flex tubing helps as it soa ...