924Board.org

Thanks for the pitcure and the info, but doesn't this car have a hot start valve located some were behind the head????????

No I refuse to lay off the ganja you can do anything with some created wire work, don't you think. A wiring harness for this car is so hard to find it's almost impossible to locate and you can't buy o ...

Hot start valve were is it located does anyone have a pitcure of its location
I can't seem to get on to smoothie site any more to look at his car. 1982 924 turbo, also were is the WUR located.

Will a wiring harness from a 1987 944 fit a 1982 924 turbo?

the car is a 1982 924 turbo. Will a wiring harness from a 1987 944 fit in a 1982 924

931 everything is once again grounding out and I can't fine out why!!!!
My coil is ground again and I can't get my fuel pump relay to energize.

I had this problem before and rebui ...

Thanks for the info but I'm trying to find out exactly how to test and or remove the ignition switch. Please don't get offended by my new post. I don't see a 6mm allen bolt on my steering coloum and ...

Can some one tell me exactly how to test and or take out the ignition switch.

How do you test the ignition switch? How do you remove the switch, I look through the haynes manual and couldn't find it.

Now that doesn't sound to good!!!! New question how do you check the ignition switch? Fuel pump relay pin 15and 31 energizes the relay when you turn on the key which in turn will send the voltage from ...

Yes I used a new head gasket and it aligned right and no the valve was not to long I matched it up with another valve from the head perfect match. When I do a leak down test on the no.1 cylinder I hea ...

That's the point valve timing!! I don'tknow if it's correct I'm looking at the mark on the cam wheel and the postion of the rotor pointing at no.1 is this correct? No cracks or holes piston were fine ...

My question is, when you turn on the ignition key to on does all of your gauges cut off and then when you start to start it do all of them come back on??? I'm thinking I have a bad switch also.

I wish I could have a good repair day

way to go!!!!

Thanks for the reply, but I still need answer to the other question. Yes 95 does sound a lot low I think it was about 125psi before I pulled the head off.

What am I doing wrong? I am a damn go ...