924Board.org

Done some more research, and found that I did buy my the clutch disk new/used from the guy I bought the engine from. Was intended for a 944 NA, so it should work. I'm checking with him to see if he ha ...

Been getting my son's 924S running and hit a snag with the clutch. Already replaced the slave, master cyls, and rubber hose between. Checked clark's page and measured the travel. It measure 17.5-18mm. ...

Rich,

I'm chasing the very same problem on my 87-924S (US). There is no relay on this year. I'm not getting volts to the fuses. I pulled the switch and checked it, and it checked out OK. I also rep ...

Thanks Peter - that's exactly what I needed. The wimpy schematic in the Haynes manual has no pin numbers. Duh - who's gonna need that?

Regards,

Smoothie,

Thanks for the feedback. My 924 book shows the relay for the headlights, but the early 944 chart I found didn't show one. Good to know its NOT supposed to be there.

I was hoping to fi ...

I need to test my headlight switch for an 87-924S (or early 944). Part number is 477-941-531-G. The early 944 Haynes manual is useless - no schematics with sufficient detail.

I'm looking for a good ...

I'm in the process of debugging some minor electrical problems also:

low beams don't come on, high-beams do. Likely the relay.
low speed & temp-driven fan don't run, A/C turns both fans on hig ...

Doing some routine maintenance on my 87 - 924S, I noticed two sensors in the head near the front of the engine (drivers side). One has a single wire, the other has a connector. Which is which? I could ...

Thanks guys. I'll take a look in the next week and get back with what I find.

aweizd,

Here's a no-brainer you can check. IN that same area is the oil filter. If you haven't already - check to make sure its snug. The PO for my car had one of these oil-lube-tuneup places do hi ...

EXCELENT RACING !

This is nobody throwing these words but.... i feel that your 924 is a WAY MORE advanced and fast vehicle than that BMW....and if you only would dare more and push the other driver ...

You can have mine for the price of postage, my wife and I are both over six feet tall, so I have no need for them.

Chrenan,

Sent you a PM.

Thanks.

OK, let me try again.

I have an 87 - 924S. I attempted the 944 fix from the link provided. I even went out and bought the parts. But under the dash - near the steering column - my setup is nothing ...

924RACR,

Thanks for the info, as I have the same problem, but the link is for 944's. The 924S has the 924 interior with quite different setup. Is there any data on the 924 setup for similar problem ...

So out of curiosity, where can these blocks be found?

I'll need a set for my sons when they start driving.